[BRLTTY] USB support on Active Braille
Lars Bjørndal
lars at lamasti.net
Fri Nov 29 14:48:15 EST 2013
Thank you, Mario!
Lars
On Fri, Nov 29, 2013 at 06:12:01PM +0100, Mario Lang wrote:
> lars at lamasti.net (Lars Bjørndal) writes:
>
> > Today, I upgraded Active Braille to 2.7 and BRLTTY to rev 6925M. (I had
> > a source rpm, and used that one for now.) I have two problems when
> > running Active Braille on USB:
> >
> > 1. If Active Braille shows the startup message when starting BRLTTY, I
> > get a message about "Saving configuration!". I can cancel that message
> > by pressing esc, and activate PC-mode to operate normally with BRLTTY.
> > However, this seems to be a bug.
>
> I still see this occasionally, but the good new is:
>
> > 2. When exiting BRLTTY, I cannot turn off the Active braille. I do need to
> > reset it by holding the on/off button for a while.
>
> That this bug has just been fixed since revision 8157.
> Took us more then thausand commits to (accidentally) find this. :-)
>
> --
> CYa,
> ??????????????? | Debian Developer <URL:http://debian.org/>
> .''`. | Get my public key via finger mlang/key at db.debian.org
> : :' : | 1024D/7FC1A0854909BCCDBE6C102DDFFC022A6B113E44
> `. `'
> `- <URL:http://delysid.org/> <URL:http://www.staff.tugraz.at/mlang/>
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at mielke.cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
More information about the BRLTTY
mailing list