[BRLTTY] Can this be done?
Tom Masterson
kd7cyu at yahoo.com
Wed Aug 17 09:44:59 EDT 2011
I did not run the logging but when I do bluetooth:<address> I get the same
results as before "Error 16: Device or Resource busy"
Tom
On Tue, 16 Aug 2011, Tom Masterson wrote:
> I can try gain tonight after I get back to this computer with
> bluetooth:<address>.
>
> I used the bluetooth-wizard to pair them. It did not give any errors and
> shows up on the bluetooth device and I can't find any advice on how to check
> otherwise.
> Split is not active on the BC640 so I have no settings there. System
> preferred is bt-usb.
>
> Tom
>
> On Mon, 15 Aug 2011, Dave Mielke wrote:
>
>> [quoted lines by Tom Masterson on 2011/08/15 at 19:02 -0700]
>>
>>> I have attached the log from the brltty -bal -dserial:rfcomm0 -ldebug
>>
>> Thanks. Now it's timing out rather than saying that the device is busy. I'm
>> now
>> wondering what'll happen if you go back to specifying bluetooth:<address>
>> (after releasing rfcomm0).
>>
>> Did you ever pair the device with the host? If so, how did you do it?
>>
>>> the bluetooth settings on the bc640 are:
>>> Bluetooth Status: disconnected
>>> Set Bluetooth pairable
>>> Bluetooth: on
>>> Bluetooth pin: 0000
>>> BLuetooth name: ALVA BC640
>>
>> What about all the settings within the submenu of "Split point
>> configuration"?
>>
>> What about the "Preferred interface" setting?
>>
>> --
>> Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of
>> God.
>> Phone: 1-613-726-0014 | Ottawa, Ontario | 2011 May 21 is the End of
>> Salvation.
>> EMail: dave at mielke.cc | Canada K2A 1H7 | 2011 Oct 21 is the End of the
>> World.
>> http://FamilyRadio.com/ | http://Mielke.cc/bible/
>> _______________________________________________
>> This message was sent via the BRLTTY mailing list.
>> To post a message, send an e-mail to: BRLTTY at mielke.cc
>> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
>>
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at mielke.cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
>
More information about the BRLTTY
mailing list