[BRLTTY] Text table selection reverts back to en-nabcc
Anders Holmberg
anders at pipkrokodil.se
Tue Apr 9 14:16:19 EDT 2013
Hi!
It says unknown configuration directive.
So whats the problem then?
/A
8 apr 2013 kl. 21:39 skrev Dave Mielke <dave at mielke.cc>:
> [quoted lines by Anders Holmberg on 2013/04/08 at 17:08 +0200]
>
>> THe problem is that i have tried to use the comandline -t for text table settings but it still not working for me.
>> I type:
>> brltty -t=sv.ttb
>> No luck.
>
> Okay, that's just a misunderstanding of how options are specified. The = is for
> the long form of the options (like --text-table=). If the short form (a single
> letter) is used, you either specify the operand right away or after space.
> Also, the .ttb extension is actually optional so you can specify it or leave it
> out. Here are some examples that will work:
>
> -t sv
> -tsv
> --text-table sv
> --text-table=sv
> -t sv.ttb
> -tsv.ttb
> --text-table sv.ttb
> --text-table=sv.ttb
>
> --
> Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of God.
> Phone: 1-613-726-0014 | Ottawa, Ontario | http://Mielke.cc/bible/
> EMail: dave at mielke.cc | Canada K2A 1H7 | http://FamilyRadio.com/
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at mielke.cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
More information about the BRLTTY
mailing list