[BRLTTY] Fedora 33, Braille OK on console, no Braille in GUI
Alexander Epaneshnikov
aarnaarn2 at gmail.com
Mon Dec 21 09:10:13 EST 2020
21.12.2020 9:56, Frans-WIllem Post пишет:
> Hello all,
>
> Would someone be able to help me with getting BrlTTY running on Fedora
> 33, see below? My braille display says "Not in text mode" while in
> GUI. On the TTY-consoles, however, it works perfectly.
>
> Thank you very much.
> Frans-Willem Post
>
> On 15-12-2020 21:41, Frans-WIllem Post wrote:
>> Hello,
>>
>> Can someone point me to the steps to get BrlTTY running in GUI mode
>> with Orca? I'm using Fedora 33 and an X.org server instead of Wayland.
>>
>> On the system's TTY-consoles, BrlTTY works perfectly. I only had to
>> enable and start the service like this:
>> sudo systemctl enable brltty;
>> sudo systemctl start brltty;
>>
>> It even uses my personal Braille table, as set in /etc/brltty.conf.
>>
>> - In Orca (master), I have Braille support enabled.
>> - BrlTTY is in version "6.1 rev unknown".
>> - I'm using a Freedom Scientific Focus 40 Blue via USB, but it is
>> detected as a "Freedom Scientific Focus 3" by lsusb.
>>
>> Thanks for your help!
>>
>> Kind regards,
>> Frans-Willem Post
>>
>
>
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at brltty.app
> For general information, go to: http://brltty.app/mailman/listinfo/brltty
does your user in brlapi group?
--
Sincerely, Alexander.
More information about the BRLTTY
mailing list