[BRLTTY] Can this be done?

[Tom Masterson]

I can try gain tonight after I get back to this computer with 
bluetooth:<address>.

I used the bluetooth-wizard to pair them.  It did not give any errors and 
shows up on the bluetooth device and I can't find any advice on how to 
check otherwise.
Split is not active on the BC640 so I have no settings there.  System 
preferred is bt-usb.

Tom

On Mon, 15 Aug 2011, Dave Mielke wrote:

> [quoted lines by Tom Masterson on 2011/08/15 at 19:02 -0700]
>
>> I have attached the log from the brltty -bal -dserial:rfcomm0 -ldebug
>
> Thanks. Now it's timing out rather than saying that the device is busy. I'm now
> wondering what'll happen if you go back to specifying bluetooth:<address>
> (after releasing rfcomm0).
>
> Did you ever pair the device with the host? If so, how did you do it?
>
>> the bluetooth settings on the bc640 are:
>> Bluetooth Status: disconnected
>> Set Bluetooth pairable
>> Bluetooth: on
>> Bluetooth pin: 0000
>> BLuetooth name: ALVA BC640
>
> What about all the settings within the submenu of "Split point configuration"?
>
> What about the "Preferred interface" setting?
>
> -- 
> Dave Mielke           | 2213 Fox Crescent | The Bible is the very Word of God.
> Phone: 1-613-726-0014 | Ottawa, Ontario   | 2011 May 21 is the End of Salvation.
> EMail: dave at mielke.cc | Canada  K2A 1H7   | 2011 Oct 21 is the End of the World.
> http://FamilyRadio.com/                   | http://Mielke.cc/bible/
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at mielke.cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
>