[BRLTTY] Have a different braille table at start up.
Anders Holmberg
anders at pipkrokodil.se
Tue Jun 11 11:24:12 EDT 2013
10 jun 2013 kl. 15:14 skrev Adrian P. van Bloois <adrian at pa0rda.nl>:
> On Mon, Jun 10, 2013 at 02:40:47PM +0200, Anders Holmberg wrote:
>> Hi!
>> I know that you can put the braille table in the brltty.conf file.
>> However can you put an instruction in the startup init script so brltty starts with for example the german or the swedish table.
> Yes, with the -t YOURCHOICEOFTABLE you can do it.
>
And where should the -t parameter be in the init script?
Should it be in the /etc/init.d/brltty script or where?
Where can i read more about this so i wont clutter up the list?
/A
>> /A
>> _______________________________________________
>> This message was sent via the BRLTTY mailing list.
>> To post a message, send an e-mail to: BRLTTY at mielke.cc
>> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
>
> --
> Adri P. van Bloois
> Antonlaan 104 email: adrian at pa0rda.nl
> 3701 VG Zeist voice: +31-(0)-30-6912741
> The Netherlands fax: NONE
>
> 52 05'15.77"N 5 4'44.56"E
> QTH-locater JO 22 OC
>
> The whole point of cooking is to get as much flavour out of the
> ingredients as possible.
> -- Delia Smith
>
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY at mielke.cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
More information about the BRLTTY
mailing list